Distributor and Manufacturer's Representative ofIndustrial Storage TanksWastewater Treatment EquipmentRelated Specialties

All Categories > Wastewater Treatment Equipment > Evaporators > Samsco Atmospheric Evaporators > View Items  
Download PDF Download PDF     Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Samsco Atmospheric Evaporators

Check up to five results to perform an action.

The ET-III-W atmospheric wastewater evaporator is designed specifically to evaporate water from solutions with high solids content. This particular design eliminates any small, entrapping passages. The up AND down-draft spraying at very high flow rates produces high evaporation at moderate temperatures.

Those looking for the greatest evaporation rates at a given temperature will choose the ET-III-W for its high efficiency for any application.

Another use "made-to-order" for the ET-III-W is the dewatering of decorative and hard chrome plating solutions. The ET-III-W can be used directly on the plating tank to remove rinse spray water and fume scrubber water.

Dewatering of waste solutions (cutting oils, printing ink & paint washwater, spent chemical solutions, photo waste) save the users of ET-III-W evaporators thousands of dollars in disposal costs. Where the need is for only 3 to 4 gallons of evaporation per hour, no added heat is required. Heat for evaporation is taken from the room air that is forced through the evaporator.

Specific features include:
  • Straight-Line Air Flow; Blower, Sprays and Evaporative Panels
  • Large Volume, low RPM, Full Width Blower
  • Patented One-Piece Molded Wet-Selection NO LEAKS!
  • Double Union, CPVC Ball Valve, for Evaporation Control
  • Maximum Wet area, IN-LINE* for Easy Air & Solution Flow
  • Rounded Turns for Smooth Air Flow
  • Up to 1-1/2 HP, All Ball Bearing Motor, 1.25 Service Factor, 1ø or 3 ø available
  • Up-Facing Exhaust, NO Elbows Needed
  • Custom designed, Stay-Wet Mist Eliminator for Maximum Droplet Retention. Optional "AirScrubber ™" Available for Near-Zero Discharge
  • Choice of Pumps to Fit Your Application
  • Strong, One-Piece, Molded "Tank". *No Welded Pieces to Crack or Leak.




Compare Items
   
  Results 1 - 2 of 2 Unit of Measure: Imperial Metric Both 1 

Item #

Crated Weight

FOOTPRINT

Blower

Pump Requirements: 10 psi (23 feet of head) Required at Evaporator

ET-II-W 290 lb 56" Long, 69" High, 29" Wide 1 hp (2500 CFM) 1 hp* 21 gpm
ET-III-W 330 lb 56" Long, 69" High, 38" Wide 1-1 1/2 hp (3300 CFM) 1-1 1/2 hp* 45 gpm
  Results 1 - 2 of 2 1 
www.Core-Rosion.comSite created by ThomasNet Web Solutions and powered by Navigator Platform